How to setup a KMBox B+ Pro for DMA cheating

A KMBox B+ Pro is the input device that lets the cheat move your mouse and click for aimbot and triggerbot. It sits between your cheat PC and your gaming PC and impersonates a real mouse, so the inputs look like they're coming from normal hardware. You only need to set it up once, and the slots you plug each cable into matter, so follow the order below.

Setup steps

1) Plug a cable from the top left slot of KMBox into the cheat PC and then plug another cable from the bottom left slot of the KMBox into the gaming PC.

2) If you haven't already, download and install the KMBox driver on your cheat PC. After it has been installed restart your cheat PC and follow the next steps.

3) Load up Blurred and look in the CMD, it should say "Successfully connected to your KMBox B+". If it doesn't connect, make sure it's plugged in correctly, then do another restart, and if it still doesn't connect you can contact us on Discord as a final resort.

4) If your KMBox was found: Go to the "Debug" tab and click the "Test KMBox Move" and "Test KMBox Click" buttons, if these don't do move/click your mouse on the gaming PC fully unplug and replug the KMBox and click "Restart KMBox". If after restarting the KMBox it still doesn't work, create a ticket in the Discord and we will assist you. If the move/click tests do work then your KMBox is fully setup.

Common issues

Most KMBox B+ Pro problems come down to the cables being in the wrong slots or plugged into the wrong PC, so double check step 1 before anything else. If the move and click tests work but aimbot still doesn't move in game, make sure the KMBox is selected as your input method inside the Web Menu. Prefer a KMBox Net instead? Follow our KMBox Net guide, or use Teensy firmware as a cheaper alternative that does the same job.