How do I setup my 2nd/Cheat PC for DMA cheating?

Your cheat PC (also called the 2nd PC) is the computer that runs the Blurred software and reads memory from your DMA card. The cheat never runs on your gaming PC, which is what keeps it away from the anti-cheat. Before you start, make sure this PC is running Windows 10 or 11 and that your DMA card is plugged into it over USB 3.0. This only needs to be done once.

New to DMA cheating? Start with our What is a DMA? guide to understand how the card, firmware, and input devices fit together.

Setup steps

1) Download the C++ redistributables and install them on your cheat PC

2) Download and install WebView2. This comes preinstalled with Windows 11 and some versions of Windows 10 so you probably won't need to do this step.

3) Download the DMA driver and install it onto the cheat PC. Make sure to run it as admin.

4) After the driver has been installed restart the cheat PC.

5) Make sure you plug your DMA card cable into a USB 3.0+ port on your cheat PC or else you'll face slow speeds. Also make sure the cable is plugged into the data port in your DMA card.

6) Now start up Blurred, if you get "Failed to initialize DMA" you need to restart both PCs. If this still happens after a restart, make sure to sync your system time and read the troubleshooting guide.

After setup

Once Blurred starts without the "Failed to initialize DMA" error, your cheat PC is ready. From here, set up your input device such as a KMBox Net or KMBox B+ Pro so the aimbot can move your mouse. If a USB 3.0 port gives you slow speeds, try a different port directly on the motherboard rather than a front-panel or hub port. You only need to generate a memory map (MMAP) if you run into connection problems or missing ESP/aimbot, so most people can skip it.